DIY Pacifier Clip Tutorial (No Sew!)

I'm going to show you how to make the worlds easiest pacifier clip! These are cheap and very quick to make. You could whip some of these up as a baby shower gift, make plenty to match all of your child's outfits, or you could even make then and sell them on the side to make a bit of pocket change.

 

Supplies Needed:

• Snap pliers or a snap press
• sicissors
• 12 inches of grosgrain ribbon (5/8 or 1 inch)
• 3 sets of plastic size 20 snaps (2 female parts, 1 male part, and 3 caps)
• 1 suspender clip (5/8 or 1 inch - match it to the size of ribbon you choose)
• lighter
• 1 silicone O ring (22mm)
• awl

Snaps I used in this video can be found here. http://www.kamsnaps.com/Size-20-c33/

The O rings I used (not where I bought them but just a random link- I forgot where I actually bought them...some where on ebay I think) http://www.etsy.com/listing/91956311/...

Snap pliersI used in this video were purchased here. http://www.kamsnaps.com/Snap-Pliers-H...

I bought the ribbon some where on Ebay but can be bought at any craft store or Walmart.

The ribbon in this video was 5/8 and the suspender clip was also 5/8. You could also use 1 inch just be sure that the ribbon size matches the suspender clip size.

I bought the pacifiers at Buy Buy Baby.

Check out this video for a step by step set of instructions.